Inside The Made To Order Process For A Handcrafted Helmet

A handcrafted helmet shell starts with a base material, commonly fibreglass or a composite blend, layered and shaped by hand rather than produced purely by mould and machine. Each layer adds strength, and the shaping stage is where a lot of the time in production actually goes.

A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.

For replacement visors and care products, see Hedon London.

ECE 22.06 is the current European standard that motorcycle helmets are tested against, and it replaced the older ECE 22.05 standard with a wider and more demanding set of tests. Helmets are checked for impact absorption at multiple points on the shell, not just the crown, and the standard also tests rotational forces, which earlier standards largely ignored.

To see the certification behind our own range, visit Hedon London.

To compare our full face and open face ranges side by side, see Hedon London.