What Goes Into A Handcrafted Helmet Shell

A handcrafted helmet shell starts with a base material, commonly fibreglass or a composite blend, layered and shaped by hand rather than produced purely by mould and machine. Each layer adds strength, and the shaping stage is where a lot of the time in production actually goes.

Any impact, including a helmet dropped from a moderate height, can compress the inner liner in ways that are not visible from outside. A helmet is designed to absorb one significant impact by sacrificing that inner material, so a helmet involved in a crash should always be replaced, not inspected and reused.

This is slower than fully automated manufacturing, and that is the point. A handcrafted shell trades speed for a level of finish and individual attention that a purely machine made helmet does not offer.

From there, the build follows the same certified construction as the standard range. Made to order does not mean a shortcut around testing, it means the standard process is carried out around one person's measurements and preferences instead of a general size run.

Once the shell is formed and cured, it moves through finishing: sanding, painting or leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.

To compare our full face and open face ranges side by side, see Hedon.